Rohde & Schwarz CMW 500 - Page 146

R&S
®
CMW 500 Command Reference
Instrument-Control Commands
Operating Manual 1202.3986.32 – 03 126
Characteristics Firmware version V1.00
SYSTem:COMMunicate:NET:HOSTname '<Host>'
Selects the host name (computer name) of the R&S CMW 500. The host name
(without the domain) is part of the VISA address string for LAN-based connections.
'<Host>' String parameter, see example below.
Def. value: – (a *RST does not affect the LAN service settings)
Example SYSTem:COMMunicate:NET:HOSTname
'hh303132.company.net'
Define the host name.
Characteristics Firmware version V1.00
SYSTem:COMMunicate:NET:DHCP <Boolean>
Enables or disables Dynamic Host Configuration Protocol (DHCP).
<Boolean> ON: DHCP enabled, automatic TCP/IP address setting
OFF: DHCP disabled, manual address setting
Def. value: ON (a *RST does not affect the LAN service settings)
Example SY
ST
em:COMMunicate:NET:DHCP OFF
Disable DHCP, enable manual setting of the IP address
information
Characteristics Firmware version V1.00
SYSTem:COMMunicate:NET:IPADdress '<Address>'
Defines the IP address of the R&S CMW 500. This address is valid if DHCP is disabled
(SYSTem:COMMunicate:NET:DHCP OFF).
'<Address>' String parameter, IP address consisting of four blocks (octets)
separated by dots.
Def. value: – (a *RST does not affect the LAN service settings)
Example
SYSTem:COMMunicate:NET:IPADdress '10.113.10.38'
Select a private IP address (characterized by 10 in the first
octet).
Characteristics Firmware version V1.00
SYSTem:COMMunicate:NET:SUBNet:MASK '<Address>'
Defines the subnet mask address of the R&S CMW 500. This address is valid if
DHCP is disabled (SYSTem:COMMunicate:NET:DHCP OFF).
深圳德标仪器 135-1095-0799