R&S
®
CMW 500 Command Reference
Instrument-Control Commands
Operating Manual 1202.3986.32 – 03 127
'<Address>' String parameter, subnet mask consisting of four blocks
separated by dots.
Def. value: – (a *RST does not affect the LAN service settings)
Example SYSTem:COMMunicate:NET:SUBNet:MASK
'255.255.0.0'
Select a subnet mask. W
ith this subnet mask, the first two octets
Characteristics Firmware version V1.00
SYSTem
:COMM
uni
cate:NET:G
ATeway '
<Address
>'
Defines the default gateway of the R&S CMW 500. This address is valid if DHCP is
disabled (SYSTem:COMMunicate:NET:DHCP OFF).
'<Address>' String parameter, gateway consisting of four blocks separated
by dots.
Def. value: – (a *RST does not affect the LAN service settings)
Example SYSTem:COMMunicate:NET:GATeway '10.113.0.1'
Select the default gateway.
Characteristics Firmware version V1.00
SYSTem:COMMunicate:NET:DNS:ENABle <Boolean>
Enables or disables dynamic DNS address configuration.
<Boolean> ON: Dynamic DNS enabled, automatic DNS address setting
OFF: Dynamic DNS disabled, manual address setting
Def. value: ON (a *RST does not affect the LAN service settings)
Example SY
ST
em:COMMunicate:NET:DNS:ENABle OFF
Disable dynamic DNS address configuration, enable manual
address setting.
Characteristics Firmware version V1.00
SYSTem
:COMM
uni
cate:NET:D
NS '<Prefe
rred>',
<
Alternate>'
Defines the preferred and the alternate DNS addresses of the R&S CMW 500. The
addresses are valid if dynamic DNS address configuration is disabled
(SYSTem:COMMunicate:NET:DNS:ENABle OFF).
'<Preferred>',
'<Alternate>'
String parameters, DNS addresses consisting of four blocks
separated by dots.
Def. value: – (a *RST does not affect the LAN service settings)
Example SYSTem:COMMunicate:NET:DNS '10.0.2.166',
'10.0.23.159'
Select the DNS addresses.
To Next Page
Loading...
