R&S
®
CMW 500 GPRF Applications
GPRF GUI Reference
Operating Manual 1202.3986.32 – 03 150
List mode configuration and operation
Use the hotkeys associated with the Sequence Config. softkey to operate the GPRF
generator in list mode.
GPIB command:
SOURce:GPRF:GENerator<i>:LIST:MODE
List Configuration > Dwell Time
Transmission time on each frequency/level step in "Auto or Single" mode. The value is
not used in the other list modes.
The total time for the generator to step through a single cycle is the dwell time times
the number of steps (Stop Index – Start Index + 1).
GPIB command:
SOURce:GPRF:GENerator<i>:LIST:DTIMe
List Configuration > Frequency / Level List
Definition of 2000 not necessarily different pairs of frequencies and levels. The actual
RF generator level at each frequency (Peak Envelope Power) is equal to the "Level
(RMS)" plus the "Digital Gain". The value range for the frequency covers the entire
configurable value range of the instrument, the level range depends on the selected
RF connector.
Digital Gain
The Digital Gain parameter provides direct access to the IF levels, while the RF Level
parameter controls the level in the RF path. The Digital Gain parameter can be used
for fine-tuning of the list mode signal (IF hopping).
GPIB command:
SOURce:GPRF:GENerator<i>:LMODe:FREQuency
SOURce:GPRF:GENerator<i>:LMODe:RFLevel
SOURce:GPRF:GENerator<i>:LIST:DGAin
7.2.2 Power: Parameters and Settings
The "Power" measurement is configured using the following groups of settings:
Measurement Control Settings
Signal Routing and Analyzer Settings
Measurement Control Parameters
To Next Page
Loading...
