R&S
®
CMW 500 GPRF Applications
GPRF GUI Reference
Operating Manual 1202.3986.32 – 03 155
CMW 500 provides the following filters of fixed shape:
The RRC filter with a roll-off = 0.22 and a 3.84 MHz bandwidth specified for
WCDMA TX tests ("WCDMA" filter, see standard 3GPP 34.121).
The 1.4 MHz-wide baseband receiver filter specified for CDMA 2000 TX tests
("CDMA" filter; see standard TIA/EIA/IS-2000.2-A).
GPIB command:
CONFigure:GPRF:MEASurement<i>:POWer:FILTer:TYPE
CONFigure:GPRF:MEASurement<i>:POWer:FILTer:GAUSs:BWIDth
CONFigure:GPRF:MEASurement<i>:POWer:FILTer:BANDpass:BWIDth
7.2.2.4 Power Configuration: List Configuration
The "List Configuration" parameters activate and configure the list mode of the
GPRF "Power" measurement.
Power Configuration: List Configuration
List Mode
Selects the list mode. "Off" means that the "Power" measurement yields results at a
single power/frequency step. If the "List Mode" is switched on, the R&S CMW 500
measures a list of power steps in accordance with the "List Mode" settings.
GPIB command:
CONFigure:GPRF:MEASurement<i>:POWer:LIST
List Section
Defines the step range to be used in list mode. The R&S CMW 500 measures all steps
between the Start Index and the Stop Index in the List; the number of steps measured
(Count = Stop Index – Start Index + 1) is displayed for information.
GPIB command:
CONFigure:GPRF:MEASurement<i>:POWer:LIST:STARt
CONFigure:GPRF:MEASurement<i>:POWer:LIST:STOP
CONFigure:GPRF:MEASurement<i>:POWer:LIST:COUNt?
Freq. / Exp. Nom. Pow. List
Definition of 500 not necessarily different pairs of frequencies and levels. The value
range for the frequency covers the entire configurable value range of the instrument,
To Next Page
Loading...
