R&S
®
CMW 500 GPRF Applications
GPRF GUI Reference
Operating Manual 1202.3986.32 – 03 161
remote control.
GPIB command:
INITiate:GPRF:MEASurement<i>:EPSensor etc.
FETCh:GPRF:MEASurement<i>:EPSensor:STATe?
FETCh:GPRF:MEASurement<i>:EPSensor:STATe:ALL?
Start Zeroing
Initiates zeroing of the external power sensor. The "Start Zeroing" hotkey is associated
with the "EPS" measurement control softkey.
GPIB command:
CALibration:GPRF:MEASurement<i>:EPSensor:ZERO
7.2.3.2 External Power Sensor Configuration
The External Power Sensor measurement is configured using the parameters in the
External Power Sensor Configuration dialog described below.
External Power Sensor configuration
Frequency
Specifies the input frequency at the power sensor. The value is used for the frequency-
response correction of the sensor measurement result.
Although R&S NRP sensors measure the RF power over a wide bandwidth, the correct
frequency of the RF signal should be entered for maximum accuracy.
GPIB command: CONFigure:GPRF:MEASurement<i>:EPSensor:FREQuency
Statistic Count
Defines the number of measurement intervals per measurement cycle (single shot
measurement); see Statistical Settings. This value is also relevant for continuous
measurements, because the averaging procedures depend on the statistic count; see
To Next Page
Loading...
