R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 173
Issues of special interest for all commands:
MEAS<i> Abbreviation of "MEASurement<instance>". For better readability only
the abbreviated form (which is also accepted by the instrument) is given
in the command reference.
It is possible to use up to four instances of the same firmware
application in parallel.
For further information refer to Firmware Applications.
7.4.1.1 Command Groups (General Measurement Settings)
Signal Routing Page
ROUTe:GPRF:MEAS<i>:RFSettings:CONNector .....................................................................................173
CONFigure:GPRF:MEAS<i>:RFSettings:EATTenuation...........................................................................173
Analyzer Settings Page
CONFigure:GPRF:MEAS<i>:RFSettings:ENPower ..................................................................................174
CONFigure:GPRF:MEAS<i>:RFSettings:UMARgin ..................................................................................174
CONFigure:GPRF:MEAS<i>:RFSettings:FREQuency ..............................................................................174
7.4.1.2 Signal Routing
The following commands select the path and connector for the generator and define an
external attenuation value.
ROUTe:GPRF:MEAS<i>:RFSettings:CONNector <Input Connector>
Selects the input connector for the measured RF signal.
<Input Connector> RF1C: RF 1 COM
RF2C: RF 2 COM
Def. value: RF1C
Example See Specifying General Measurement Settings
Characteristics Firmware version V1.00
CONFigure:GPRF:MEAS<i>:RFSettings:EATTenuation <External Att>
Defines an external attenuation (or gain, if the value is negative), to be applied to the
selected RF input connector (ROUTe:...:MEAS<i>:RFSettings:CONNector).
<External Att> Range: –50.00 dB to +90.00 dB (increment 0.01 dB)
Def. value: 0.00 dB
To Next Page
Loading...
