Rohde & Schwarz CMW 500 - Generator Control and States; Signal Routing

R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 176
SOURce:GPRF:GEN<i>:DTONe:RATio ...................................................................................................178
SOURce:GPRF:GEN<i>:DTONe:LEVel<source>? ...................................................................................179
SOURce:GPRF:GEN<i>:ARB:FILE ..........................................................................................................179
List Mode Settings Page
SOURce:GPRF:GEN<i>:LIST ..................................................................................................................179
SOURce:GPRF:GEN<i>:LIST:SSTop.......................................................................................................180
SOURce:GPRF:GEN<i>:LIST:COUNt? ...................................................................................................180
SOURce:GPRF:GEN<i>:LIST:CINDex .....................................................................................................180
SOURce:GPRF:GEN<i>:LIST:MODE.......................................................................................................180
SOURce:GPRF:GEN<i>:LIST:DTIMe.......................................................................................................181
SOURce:GPRF:GEN<i>:LIST:FREQuency ..............................................................................................181
SOURce:GPRF:GEN<i>:LIST:FREQuency? ............................................................................................181
SOURce:GPRF:GEN<i>:LIST:RFLevel ....................................................................................................181
SOURce:GPRF:GEN<i>:LIST:RFLevel?...................................................................................................181
SOURce:GPRF:GEN<i>:LIST:DGAin .......................................................................................................182
SOURce:GPRF:GEN<i>:LIST:DGAin? .....................................................................................................182
7.4.2.2 Generator Control and States
The following command controls the RF generator and retrieve its state.
SOURce:GPRF:GEN<i>:STATe <State>
Turns the generator on or off (see Generator Control).
<State> Switch generator ON or OFF
Return for query: OFF: generator switched off
PEND: generator switched on but no signal available yet
ON: generator switched on, signal available
Def. value: OFF
Example See Generating a CW Signal
Characteristics Firmware version V1.00
7.4.2.3 Signal Routing
The following commands select the input path and connector and define an external
attenuation value.
深圳德标仪器 135-1095-0799