Rohde & Schwarz CMW 500 - Source:gprf:gen<I>:List:cindex; Source:gprf:gen<I>:List:count; Source:gprf:gen<I>:List:mode; Source:gprf:gen<I>:List:sstop

R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 180
Characteristics Firmware version V1.00
SOURce:GPRF:GEN<i>:LIST:SSTop <Start Index>, <Stop Index>
Defines the number of the first and last frequency/level step in the sequence list that is
measured. These parameters are relevant for the AUTO, SING, and ESINgle list
modes only (see SOURce:GPRF:GEN<i>:LIST:MODE). The stop index must not be
smaller than the start index.
<Start Index>, Range: 0 to 1999,
Def. value: 0
<Stop Index> Range: 0 to 1999,
Def. value: 19
Example See Using the Generator List Mode
Characteristics Firmware version V1.00
SOURce:GPRF:GEN<i>:LIST:COUNt?
Queries the number of frequency/level steps of the RF generator in list mode.
Returned values:
<Steps> Number of frequency/level steps in list mode
Range: 1 to 2000
Example See Using the Generator List Mode
Characteristics Firmware version V1.00
SCPI: Query only
SOURce:GPRF:GEN<i>:LIST:CINDex <Current Index>
Number of frequency/level step in the sequence list. This parameter is relevant in
"Step" mode only (SOURce:GPRF:GEN<i>:LIST:MODE STEP).
<Current Index> Range: 0 to 1999,
Def. value: 0
Characteristics Firmware version V1.00
SOURce:GPRF:GEN<i>:LIST:MODE <Mode>
Defines how the RF generator runs through the list.
<Mode> AUTO: The generator cycles through the list.
SING: The generator runs through the list for a single time.
STEP: Manual selection of a single frequency/level step.
Example See Using the Generator List Mode
深圳德标仪器 135-1095-0799