R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 193
Characteristics Firmware version V1.00
SCPI: Query only
For additional information concerning syntax elements and returned values refer to
Power Measurement Commands.
FETCh:GPRF:MEAS<i>:POWer:SDEViation?
READ:GPRF:MEAS<i>:POWer:SDEViation?
Returns the standard deviation RF power trace values, see Power: Results.
Returned values
<Reliability>, Reliability indicator
<Std Dev 1>,
...,
<Std Dev n>
Standard deviation of RMS power results for each measured
power step. If the list mode is switched off, a single value is
returned (n = 1). In list mode, the total number n of results is
equal to the list count
(CONFigure:GPRF:MEAS<i>:POWer:LIST:COUNt?).
Range: 0.0 dB to +78 dB
Def. unit: dB
Example See Single Shot and Continuous Power Measurements
Characteristics Firmware version V1.00
SCPI: Query only
For additional information concerning syntax elements and returned values refer to
Power Measurement Commands.
7.4.4 External Power Sensor Measurement Commands
The commands valid for the External Power Sensor measurement are divided into the
groups listed below. For an overview of the commands refer to Command Groups.
Measurement Control and States
Zeroing
Statistical Settings
Sensor Configuration
Measurement Results
Issues of special interest for all commands:
MEAS<i> Abbreviation of "MEASurement<instance>". For better readability only
the abbreviated form (which is also accepted by the instrument) is given
in the command reference.
It is possible to use up to four instances of the same firmware
application in parallel.
For further information refer to Firmware Applications.
To Next Page
Loading...
