Rohde & Schwarz CMW 500 - GSM Multi Evaluation: Parameters and Settings; Measurement Control; Signal Routing and Analyzer Settings

R&S
®
CMW 500 GSM Applications
GSM GUI Reference
Operating Manual 1202.3986.32 – 03 224
8.2.1 GSM Multi Evaluation: Parameters and Settings
The GSM multi-evaluation measurement is configured using the following groups of
settings:
Measurement Control
Signal Routing and Analyzer Settings
Measurement Control Settings
Trigger
Limits
Display
Filter
The most important measurement settings are also displayed in the measurement
dialog.
The measurement dialog provides all Measurement Results.
8.2.1.1 Measurement Control
The measurement is turned on or off using the "Multi Evaluation" measurement control
softkey and the ON | OFF or RESTART | STOP front panel keys.
Multi Evaluation (Softkey)
Turns the measurement on or off; see Measurement Control. The measurement state
is shown in the softkey. Additional measurement substates may be retrieved via
remote control.
GPIB command:
INITiate:GSM:MEASurement<i>:MEValuation etc.
FETCh:GSM:MEASurement<i>:MEValuation:STATe?
FETCh:GSM:MEASurement<i>:MEValuation:STATe:ALL?
8.2.1.2 Signal Routing and Analyzer Settings
The measurement is configured using the parameters in the "Multi Evaluation
Configuration" dialog. The following parameters configure the RF input path.
深圳德标仪器 135-1095-0799