R&S
®
CMW 500 GSM Applications
GSM Programming
Operating Manual 1202.3986.32 – 03 243
CONFigure:GSM:MEASurement:MEValuation:TRIGger:THReshold -2.5E+1
CONFigure:GSM:MEASurement:MEValuation:TRIGger:DELay 0
CONFigure:GSM:MEASurement:MEValuation:TRIGger:TOUT 1.0E+3
CONFigure:GSM:MEASurement:MEValuation:MSLots 0, 1, 0
WAITKEY >General configuration completed, press "OK" to start
power measurement<
8.3.1.4 Performing Single Shot Measurements
FPRINT ************************************************************
FPRINT Power vs. time configuration: change reference power mode for 8PSD-
modulated
FPRINT bursts, select a wider IF filter, start a single-shot power vs. time measurement
and return the average
FPRINT burst power trace. Query the measurement status (should be "RDY" and
"RDY ,ADJ,ACT"
FPRINT ************************************************************
CONFigure:GSM:MEASurement:MEValuation:RPMode CURRent
CONFigure:GSM:MEASurement:MEValuation:PVTime:FILTer G10M
READ:GSM:MEASurement:MEValuation:TRACe:PVTime:AVERage?
WAITKEY >Single-slot measurement completed, press "OK" to
measure average EVM<
FPRINT ************************************************************
FPRINT Read the average error vector magnitude trace obtained in the
FPRINT last measurement without re-starting the measurement
FPRINT ************************************************************
READ:GSM:MEASurement:MEValuation:TRACe:EVMagnitude:AVERage?
8.3.1.5 Single Shot and Continuous Measurements
FPRINT ************************************************************
FPRINT Start single-shot measurement, return magnitude error trace.
FPRINT Return maximum magnitude error trace and maximum phase (without
repeating
FRPRING the measurement. Query the measurement state (should be "RDY").
FPRINT ************************************************************
INIT:GSM:MEASurement:MEValuation
FETCh:GSM:MEASurement:MEValuation:TRACe:MERRor:MAXimum?
FETCh:GSM:MEASurement:MEValuation:TRACe:PERRor:MAXimum?
FETCh:GSM:MEASurement:MEValuation:STATe?
To Next Page
Loading...
