Rohde & Schwarz CMW 500 - Selecting Specific Burst Types

R&S
®
CMW 500 GSM Applications
GSM Programming
Operating Manual 1202.3986.32 – 03 245
INIT:GSM:MEASurement:MEValuation
Waitkey >Spectrum measurement initiated, press "OK" to continue<
FETCh:GSM:MEASurement:MEValuation:TRACe:SMODulation:FREQuency?
FETCh:GSM:MEASurement:MEValuation:TRACe:SSWitching:FREQuency?
8.3.1.7 Selecting Specific Burst Types
FPRINT
************************************************************
FPRINT Select only GMSK-modulated normal bursts with a definite
FPRINT training sequence (TSC 0) . Start a single-shot modulation measurement
FPRINT and return the statistics of the EVM results
FPRINT ************************************************************
CONFigure:GSM:MEASurement:MEValuation:TSEQuence TSC1
CONFigure:GSM:MEASurement:MEValuation:MVIew GMSK, GMSK, GMSK,
GMSK, GMSK, GMSK, GMSK, GMSK
READ:GSM:MEASurement:MEValuation:EVMagnitude?
FPRINT ************************************************************
FPRINT Perform a multi-slot measurement, use a frame trigger, knowing
FPRINT that slots no. 5, 6, and 7 of the analyzed signal are inactive
FPRINT ************************************************************
CONFigure:GSM:MEASurement:MEValuation:TRIGger:SOURce ACQuisition
CONFigure:GSM:MEASurement:MEValuation:AMODe GAP
CONFigure:GSM:MEASurement:MEValuation:GLENgth 3
FPRINT ************************************************************
FPRINT Perform a multi-slot measurement, use a frame trigger, knowing
FPRINT that slots no. 2, 3, and 4 of the analyzed signal are 8PSK-modulated,
FPRINT and that the remaining slots are inactive
FPRINT ************************************************************
CONFigure:GSM:MEASurement:MEValuation:TRIGger:SOURce ACQuisition
CONFigure:GSM:MEASurement:MEValuation:AMODe PATTern
CONFigure:GSM:MEASurement:MEValuation:APATtern OFF, OFF, EDGE,
EDGE, EDGE, OFF, OFF, OFF
深圳德标仪器 135-1095-0799