R&S
®
CMW 500 GSM Applications
GSM Command Reference
Operating Manual 1202.3986.32 – 03 264
acquisition mode is active (CONFigure:GSM:MEAS<i>:MEValuation:AMODe
PATTern).
<Pattern 0>,
...,
<Pattern 7>
Pattern selection for corresponding timeslot (0 to 7)
OFF: No signal expected
GMSK: GMSK-modulated normal bursts
EDGE: 8PSK-modulated normal bursts
Def. value: OFF (timeslots 0, 6, 7), EDGE (timeslots 1 to 5)
Example See Selecting Specific Burst Types
Characteristics Firmware version V1.00
8.4.2.7 Power vs. Time Settings
The following commands configure the "Power vs. Time " measurement.
CONFigure:GSM:MEAS<i>:MEValuation:RPMode <Mode>
Defines how the reference power, i.e. the 0-dB line in the measurement diagram, is
calculated.
<Mode> CURRent: Current
AVERage: Average
DCOMpensated: Data Compensated
Def. value: AVERage
Example See Performing Single Shot Measurements
Characteristics Firmware version V1.00
8.4.2.8 Spectrum Modulation Settings
The following commands define settings for spectrum modulation frequency (ACP
modulation) measurements.
CONFigure:GSM:MEAS<i>:MEValuation:SMODulation:FOFFsets
<Status 0> | <Freq Offset 0>, ..., <Status 19> | <Freq Offset 19>
Defines the frequency offsets to be used for ACP modulation measurements. The
offsets are defined relative to the analyzer frequency. Up to 20 offsets can be defined
and enabled.
To Next Page
Loading...
