Rohde & Schwarz CMW 500 - Command Groups (Multi Evaluation)

R&S
®
CMW 500 WCDMA Applications
WCDMA Command Reference
Operating Manual 1202.3986.32 – 03 335
Current and
statistical
values
The R&S CMW 500 repeats measurements according to the selected
statistic count and repetition mode. Consecutive measurement values
are stored and used to calculate statistical results, e.g. average,
minimum, maximum and standard deviation.
For a description of the statistical methods refer to Statistical Results.
Number of trace
values
The number of measured values of a trace depends on the
number of measured slots
(CONFigure:...:MEAS<i>:MEValuation:MSCount). The
trace contains one value per measured slot for full slot
measurements and two values per measured slot for half slot
measurements
(CONFigure:...:MEAS<i>:MEValuation:MPERiod:MODul
ation).
Global Reliability Indicator
The common reliability indicator is the first value in the output arrays of the
FETCh...? and READ...? queries.
e.g. FETCh:GPRF:MEASurement<i>:EPSensor:CURRent?
Response: 0, 10.22, 10.15, 10.01, 10.29, 100 (reliability: 0, 5 numeric measurement
values)
In the present firmware version, the common reliability indicator is always set to zero.
9.4.2.1 Command Groups (Multi Evaluation)
Measurement Control and States Page
INITiate:WCDMa:MEAS<i>:MEValuation..................................................................................................339
ABORt:WCDMa:MEAS<i>:MEValuation ...................................................................................................339
STOP:WCDMa:MEAS<i>:MEValuation ....................................................................................................339
FETCh:WCDMa:MEAS<i>:MEValuation:STATe? .....................................................................................340
FETCh:WCDMa:MEAS<i>:MEValuation:STATe:ALL?..............................................................................340
Measurement Parameters Page
CONFigure:WCDMa:MEAS<i>:MEValuation:REPetition...........................................................................341
CONFigure:WCDMa:MEAS<i>:MEValuation:SCONdition.........................................................................341
CONFigure:WCDMa:MEAS<i>:MEValuation:MOEXception......................................................................342
CONFigure:WCDMa:MEAS<i>:MEValuation:MSCount.............................................................................342
CONFigure:WCDMa:MEAS<i>:MEValuation:PSLot..................................................................................342
CONFigure:WCDMa:MEAS<i>:MEValuation:MSLot .................................................................................342
Statistical Settings (Modulation) Page
CONFigure:WCDMa:MEAS<i>:MEValuation:MPERiod:MODulation .........................................................343
深圳德标仪器 135-1095-0799