R&S
®
CMW 500 WCDMA Applications
WCDMA Command Reference
Operating Manual 1202.3986.32 – 03 344
(WOOFfset) or subtracted out (NOOFfset).
<Analysis Mode> WOOFfset: With origin offset
NOOFfset: No origin offset
Def. value: WOOFfset
Example See Specifying Measurement-Specific Settings
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:CDTHreshold:MODulation
<Threshold>
Defines the minimum relative signal strength of the DPDCH in the WCDMA signal (if
present) to be detected and evaluated.
<Threshold> Range: –25 dB to +10 dB
Def. value: –10 dB
Def. unit: dB
Example See Specifying Measurement-Specific Settings
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:SSCalar:MODulation <Slot No.
(Table)>
Selects a particular slot within the "Measurement Length" where the R&S CMW 500
evaluates the statistical measurement results. The slot no. must be smaller than the
number of measured slots
(CONFigure:WCDMa:MEAS<i>:MEValuation:MSCount).
<Slot No. (Table)> Range: 0 to 119
Def. value: 0
Example See Specifying Measurement-Specific Settings
Characteristics Firmware version V1.00
9.4.2.5 Statistical Settings (Spectrum)
The following commands specify the scope of the spectrum measurement.
CONFigure:WCDMa:MEAS<i>:MEValuation:SCOunt:SPECtrum <Count>
Specifies the statistic count of the measurement; see Statistical Settings. The statistic
count is equal to the number of measurement intervals per single shot. Use
CONFigure:...:MEAS<i>:...:REPetition SINGleshot | CONTinuous to
select either single shot or continuous measurements.
To Next Page
Loading...
