R&S
®
CMW 500 WCDMA Applications
WCDMA Command Reference
Operating Manual 1202.3986.32 – 03 346
<Limit RMS>, Range: 0.0 % to 99.0 %
Def. value: 17.5 %
Def. unit: %
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
<Limit Peak Range: 0.0 % to 99.0 %
Def. value: 50.0 %
Def. unit: %
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
Example See Specifying Limits
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:LIMit:EVMagnitude
<Limit RMS>, <Limit Peak>
Defines upper limits for the RMS and peak values of the error vector magnitude (EVM).
<Limit RMS>, Range: 0.0 % to 99.0 %
Def. value: 17.5 %
Def. unit: %
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
<Limit Peak> Range: 0.0 % to 99.0 %
Def. value: 50.0 %
Def. unit: %
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
Example See Specifying Limits
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:LIMit:PERRor
<Limit RMS>, <Limit Peak>
Defines symmetric limits for the RMS and peak values of the phase error. The limit
check fails the UE if the absolute value of the measured phase error exceeds the
specified values.
<Limit RMS>, Range: 0.0 deg to 45.0 deg
Def. value: 10.0 deg
Def. unit: deg
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
To Next Page
Loading...
