Rohde & Schwarz CMW 500 - Configure:wcdma:meas<I>:Mevaluation:limit:cferror; Configure:wcdma:meas<I>:Mevaluation:limit:iqimbalance; Configure:wcdma:meas<I>:Mevaluation:limit:iqoffset

R&S
®
CMW 500 WCDMA Applications
WCDMA Command Reference
Operating Manual 1202.3986.32 – 03 347
<Limit Peak> Range: 0.0 deg to 45.0 deg
Def. value: 45.0 deg
Def. unit: deg
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
Example See Specifying Limits
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:LIMit:IQOFfset <Limit>
Defines an upper limit for the I/Q origin offset.
<Limit> Range: –80.0 dB to 0.0 dB
Def. value: –25.0 dB
Def. unit: dB
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
Example See Specifying Limits
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:LIMit:IQIMbalance <Limit>
Defines an upper limit for the I/Q imbalance.
<Limit> Range: –99.0 dB to 0.0 dB
Def. value: –15.0 dB
Def. unit: dB
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
Example See Specifying Limits
Characteristics Firmware version V1.00
CONFigure:WCDMa:MEAS<i>:MEValuation:LIMit:CFERror <Limit>
Defines an upper limit for the carrier frequency error.
<Limit> Range: 0 Hz to 4000 Hz
Def. value: 200 Hz
Def. unit: Hz
Additional parameters: OFF | ON (disables the limit check |
enables the limit check using the previous/default limit values)
Example See Specifying Limits
Characteristics Firmware version V1.00
深圳德标仪器 135-1095-0799