R&S
®
CMW 500 WiMAX Applications
WiMAX Command Reference
Operating Manual 1202.3986.32 – 03 388
10.3 WiMAX Command Reference
The following sections provide detailed reference information on the remote control
commands of the WiMAX application. The commands are organized as follows:
General Measurement Settings
Multi-Evaluation Measurement Commands
For an overview of all commands refer to the Alphabetical List of Commands.
10.3.1 General Measurement Settings
The commands valid for all WiMAX measurements are divided into the groups listed
below. For an overview of the commands refer to Command Groups.
Analyzer Settings
Signal Routing
Issues of special interest for all commands:
MEAS<i> Abbreviation of "MEASurement<instance>". For better readability only
the abbreviated form (which is also accepted by the instrument) is given
in the command reference.
It is possible to use up to four instances of the same firmware
application in parallel.
For further information refer to Firmware Applications.
10.3.1.1 Command Groups (General Measurement Settings)
Analyzer Settings Page
CONFigure:WIMax:MEAS<i>:RFSettings:ENPower .................................................................................389
CONFigure:WIMax:MEAS<i>:RFSettings:UMARgin .................................................................................389
CONFigure:WIMax:MEAS<i>:RFSettings:FREQuency .............................................................................389
Signal Routing Page
ROUTe:WIMax:MEAS<i>:RFSettings:CONNector....................................................................................389
CONFigure:WIMax:MEAS<i>:RFSettings:EATTenuation..........................................................................390
10.3.1.2 Analyzer Settings
The following commands configure the RF input path.
To Next Page
Loading...
