EasyManua.ls Logo

Rohde & Schwarz CMW500 Series - Page 20

Rohde & Schwarz CMW500 Series
291 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preparing for Use
R&S
®
CMW500
20User Manual 1173.9463.02 ─ 02
The following connectors are available on all instruments:
LAN REMOTE is an RJ-45 connector. Use this connector to integrate the instrument
to a Local Area Network, primarily for remote control purposes.
REF IN is a BNC input for an external reference frequency. Use this connector to
synchronize the R&S CMW500 to another device.
REF OUT 1 is a BNC output for the internal reference frequency of the R&S CMW500.
Use this connector to synchronize other instruments to the tester.
The USB connectors can be used to connect e.g. a keyboard, mouse or other pointing
devices, a printer or an external storage device (USB stick, CD-ROM drive etc.).
The USB REMOTE connector can be used for remote control of the instrument.
TRIG A and TRIG B are two BNC connectors for external trigger signals.
The following connectors are optional:
A LAN SWITCH with two RJ-45 connectors is available as option R&S CMW-B660A
and R&S CMW-B661A. It routes data provided by internal boards to the processor
(e.g. payload provided by signaling units).
The BNC connectors SYS SYNC OUT 1, OUT 2, OUT 3 and SYS SYNC IN are
provided with option R&S CMW-S550M. They are used to provide or receive time
information.
LAN DAU is an RJ-45 connector. It is provided with the Data Application Unit (DAU),
option R&S CMW-B450A. The DAU is required when testing End-to-End (E2E) IP
data transfer and mandatory when using the instrument for protocol testing (U-plane
tests).
An I/Q board is available as option R&S CMW-B510A. It provides four digital con-
nectors (labeled "DIG IQ IN/OUT 1", "DIG IQ OUT 2", "DIG IQ IN/OUT 3", and "DIG
IQ OUT 4") for input and output of digital IQ data plus two bidirectional BNC connec-
tors (labeled "AUX A" and "AUX B") for control, clock and trigger signals.
A second I/Q board is available as option R&S CMW-B520A. It provides the digital
connectors "DIG IQ IN/OUT 5", "DIG IQ OUT 6", "DIG IQ IN/OUT 7", and "DIG IQ
OUT 8" and the BNC connectors "AUX C" and "AUX D".
Rear Panel Tour

Table of Contents

Related product manuals