Preface
R&S
®
CMW500
9User Manual 1173.9463.02 ─ 06
1 Preface
This chapter provides an overview of new features and an overview of the R&S CMW500
operating documentation.
1.1 What's New in this Revision
This revision describes version 3.0.14 and higher of the R&S CMW500 base software.
Compared to version 3.0.12 it provides the new features listed below. For extensions of
a firmware application please refer to the "What's New" in the description of the firmware
application.
●
New commands and command enhancements related to date and time settings:
–
new: SYSTem:TIME:DSTime:RULE:CATalog?
–
new: SYSTem:TIME:DSTime:RULE
–
enhanced: SYSTem:TIME:DSTime:MODE
Software Version
To check your R&S CMW500 software version, open the "Setup" dialog and click "HW/
SW Equipment". The initial software version for each remote control command is quoted
in the reference description.
1.2 Documentation Map
The R&S CMW500 documentation is delivered as help system, printed Quick Start Guide
and on CD-ROM.
1.2.1 Help System
The help system is embedded in the instrument, offering quick, context-sensitive refer-
ence to the information needed for operation and programming.
You can use the help also if you control the instrument from an external monitor. Fur-
thermore you can transfer the help to your PC and use it as a standalone help.
1.2.2 Quick Start Guide
The Quick Start Guide describes everything that is needed to put the instrument into
operation and helps you to get familiar with the R&S CMW500. It gives an introduction
to the instrument's functionality and provides procedures for typical measurement tasks.
The Quick Start Guide is delivered with each R&S CMW500.
What's New in this Revision
To Next Page
Loading...
