Rohde & Schwarz CRTU-RU - Fig. 1-7 CRTU-RU Rear View

Rear View CRTU-RU
1138.6990.12 1.8 E-2
PS/ 2
MONITOR COM 1
COM 2
IEEE 488
625
AUX 5
LPT
I
0
DATA CH1
Signal inputs and outputs
o
I
100-240VAC
3,1-1,3 A
50-400 Hz
DATA CH2
USB
REF IN
REF OUT 1
REF OUT 2
IF3 RX CH1
ETHERNET
IQ IN/OUT CH1
IQ IN/OUT CH2
REF OUT 3
NETCLK OUT IF TX CH 1
IF TX CH 2
IF RX CH 1
IF RX CH 2
IF TX CH 1 OUT
IF TX CH 2 OUT IF RX CH 2 OUT
TRIG IN A
TRIG OUT A
SLOT CLK
TRIG IN B
TRIG OUT B
BIT CLK
CHAIN IN / CONTROL A
CHAIN OUT / CONTROL B
Fig. 1-7 CRTU-RU rear view
Monitor (only with Option B7)
IF TX CH 1 OUT
IF TX CH 2 OUT
IF TX CH1
OUT
IF TX CH2
OUT
The TX outputs are used to monitor the
signals with external equipment (e.g.
spectrum analyzer).
F
RF Connectors
IF RX CH 1 OUT
IF RX CH 2 OUT
IF RX CH2
OUT
IF RX CH1
OUT
The RX outputs are used to monitor the
signals with external equipment (e.g.
spectrum analyzer).
F
RF Connectors
Reference frequency
REF I N
REF OUT 1 REF OUT 2
REF IN
REF OUT 1
REF OUT 2
Input for external reference frequency.
Output of reference frequency:
10 MHz if the internal reference frequency
or the signal of the input REF IN is used.
Output clock signal derived from the NET
CLK (divisor configurable) divided down.
F
RF Connectors
TRIG IN/OUT A/B
TRIG IN A
TRIG OUT A
TRIG IN A
TRIG OUT A
The first pair of trigger signals that can be
configured using the application.
F
RF Connectors
TRIG IN B
TRIG OUT B
TRIG IN B
TRIG OUT B
The second pair of trigger signals that can
be configured using the application.
F
RF Connectors