Software and Firmware Update
R&S
®
DDF205
68Getting Started 4073.0187.02 ─ 03
Click OK to install the "Redistributable" package. Installation will take a few minutes.
Start the Remote Access GUI via "Start"
-> "Programs" -> "R&S DDF205 GUI". The
following dialog may appear due to the Windows Firewall. Click on "Unblock" to
allow the traffic to/from the R&S DDF205
As a last step, you may have to change the Windows Firewall settings to enable the
network traffic of the R&S DDF205 GUI. For this reason, start the GUI via "Start" -
> "Programs" -> "R&S DDF205 GUI". When the GUI is displayed, the following
dialog may also appear.
Click "Unblock"
and the Windows Firewall is set to enable the network traffic of the
R&S DDF205 GUI.
GUI Installation for Remote Access
To Next Page
Loading...