Rohde & Schwarz DDF205 - Changing the IP Address; Using Update32 Tool

Software and Firmware Update
R&S
®
DDF205
69Getting Started 4073.0187.02 ─ 03
4.5 Changing the IP Address
4.5.1 Using Update32 Tool
The
IP address of the R&S DDF205 can be changed using the "Update32" tool. By
default, the R&S DDF205 is shipped with DHCP enabled.
Refer to "Retrieve Update32" under chapter 4.3, "Receiver Firmware Update for
DDF205 without front control panel", on page 58 to read the steps for retrieving and
running the "Update32" tool.
Starting the procedure
Run Update32 and allow access if there are security warnings. If a configuration
is not loaded previously, refer to "Selecting the configuration file" under "Selecting
the configuration file" on page 60 to select an appropriate configuration file. Select
"Config” -> “LAN Settings via Ethernet" as shown below:
Selecting the target R&S DDF205
The R&S DDF205, for which you want to update the IP address, needs to be
switched
on. Make sure there is a LAN connection between the R&S DDF205 and
the PC. After a short period, a new entry will be shown in the list of targets as shown
in figure 4-1. Select the appropriate target and press the "Start" button.
Changing the IP address
Make the desired changes in the LAN settings dialog as shown below. Select
“DHCP” if the R&S DDF205 is to be connected to a DHCP server.
Changing the IP Address