Rohde & Schwarz EK 896 - 1.2 Control Unit 1 REMOTE (EK 895)

V L F > H F R E C E I V E R S
f
E K 8 9 5 / E K 8 9 5
Operator Manual
f
Switching On and Off
1.2 Control Unit 1 ∫REMOTE∫ (EK 895)
(see Fig. 1.2)
1.2.1 General
The VLF>HF Receiver EK 895 with control unit 1 'REMOTE' does not contain any control elements
other than the power switch. Its control is carried out with the aid of a computer with control
program, Control Unit GB 899 or another receiver (EK 895 with control unit 2 'LOCAL' or Control
Unit GB 890, EK 896). In the event that there is no control program for the computer available or
such a program is to be established, the remote control commands in compliance with Section 2 of
this Operator Manual and Appendix A3 of the User Manual (6045.6712.12.xx) are required.
1.2.2 Switching On
Actuate switch ON.
a a a a
a
a a
a
a
a a
a
a
a a
a
a a a a
a a a a a
a a a a a
a a a a a
a a a a a
a a a a a
a a a a a
a a a a a
a a a a a
a a a a a
EIN
.
ON
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
EIN
.
ON
Æ LED ON is illuminated.
Æ A POWER reset (LED test and BIT) is initiated.
LED Test
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
a a a
OPTION 2
HF>TEIL
.
RF UNIT
ZF / NF PROZESSOR
.
IF / AF PROCESSOR
SYNTHESIZER
OPTION 1
Æ All LEDs must be illuminated.
BIT
Æ Module check
6075.6991.82.01
> 1.19 >