Rohde & Schwarz EK 896 - 2.5 System Functions

V L F > H F R E C E I V E R S
f
E K 8 9 5 / E K 8 9 6
Operator Manual
f
System Functions
2.5 System Functions
The following system functions are possible:
f Addressed operation
1)
f Inquiry of software version
1)
f Inquiry of IF filter bandwidths
1)
f Inquiry of options
f Signal BYPASS
1)
f Activating command IF
1)
f Inquiry of operating status
1)
f Inquiry of error status
1)
f Initiating a reset
1)
f Enabling or disabling local control
1)
f Inquiry of software type and Ident. No.
1)
1)
These commands are described in the User Manual 6045.6712.12.xx.
2.5.1 Inquiry of Options
Command syntax:
Code: OP
Reply
Parameter: ................... a
0 = no option
1 = Control Unit GB 890
8 = BCD Interface GC 890
9 = Preselector FK 890H1
11 =VLF>HF Receiver EK 895
12 =VLF>HF Receiver EK 896
13 = IF Converter (100 kHz)
14 = IF Converter UX 895 (455 kHz)
15 = EK 895S7 (quasi>continuous
bandwidth for EK 895)
16 = EK 896S7 (quasi>continuous
bandwidth for EK 896)
17 = Digital Selection FK 896 (EK 896 only)
18 = IF Processor GM 893, Mod. 03
19 = Data Link
Example 1:
Inquiry of options
Command = rAxxOP??
Æ Reply = rAxxOP1,11?
In VLF>HF Receiver EK 895 the option 'Control
Unit GB 890' is installed.
Example 2:
Inquiry of options
Command= rAxxOP??
Æ Reply = rAxxOP12,19?
In VLF>HF Receiver EK 896 the software option
Data Link is implemented.
6075.6991.82.01
> 2.7 >