R&S ESCI Receiver – MEAS Key
1166.6004.12 4.27 E-2
SORT BY
DELTA LIM
The softkey SORT BY DELTA LIMIT sorts the table in a
descending order according to the entries in the DELTA
LIMIT column .
IEC/IEEE-bus command --
ASCII FILE
EXPORT
The ASCII FILE EXPORT softkey stores the final
measurement data in a file with ASCII format on a floppy disk.
IEC/IEEE command FORM ASC;
MMEM:STOR:FIN 1,'FINAL.DAT'
The file consists of the header containing important scaling
parameters, several data sections containing the scan settings
and a data section containing the results of the final measure-
ment.
The data of the file header consist of three columns, each
separated by a semicolon:
parameter name; numeric value; basic unit
The data section for the trace date starts with the keyword "
Trace <n> Final" (<n> = number of stored trace), followed by
the measured data in one or several columns which are also
separated by a semicolon.
This format can be read in from spreadsheet calculation
programs, e.g. MS-Excel. It is necessary to define ';' as a
separator.
Note: Different language versions of evaluation programs
may require a different handling of the decimal point. It
is therefore possible to select between separators '.'
(decimal point) and ',' (comma) using softkey DECIM
SEP.
DECIM SEP
. ,
The DECIM SEP softkey selects the decimal separator
between '.' (decimal point) and ',' (comma) with floating-point
numerals for the function ASCII FILE EXPORT.
With the selection of the decimal separator different language
versions of evaluation programs (e.g. MS-Excel) can be
supported.
IEC/IEEE-bus command FORM:DEXP:DSEP POIN
To Next Page
Loading...
