Rohde & Schwarz EMI Test ReceiverESCI - Page 164

MEAS Key - Receiver R&S ESCI
1166.6004.12 4.32 E-2
MEASURE
HOLD
FINAL MEAS
STOP
FINAL MEAS
INTER
ACTIVE
STOP
FINAL MEAS
AUTOMATIC
FINAL
The HOLD FINAL MEAS softkey interrupts the
automatic run of the final measurement.
The CONTINUE FINAL MEAS submenu appears.
With the final measurement halted all receiver
settings can be modified for example for examining
the signal in detail.
The mode of the measurement (automatic or
interactive) can again be selected.
The final measurement can be started with the
MEASURE softkey.
IEC/IEEE-bus command --
AUTOMATIC
FINAL
The AUTOMATIC FINAL softkey selects the
automatic mode for the final measurement (see
above).
IEC/IEEE-bus command :FME:AUTO ON
INTER
ACTIVE
The INTERACTIVE softkey selects the interactive
mode for the final measurement as described
above.
IEC/IEEE-bus command :FME:AUTO OFF
MEASURE
The MEASURE softkey continues with the final
measurement. The final measurement starts at the
next frequency entry on the peak list or at a marked
frequency if one or several lines have been skipped
with the SKIP FREQUENCY softkey.
IEC/IEEE-bus command --
STOP
FINAL MEAS
The STOP FINAL MEAS softkey halts the final measurement. The
final measurement starts from the beginning on a new start. The
previously collected data are lost.
IEC/IEEE-bus command --