SWEEP Key - Receiver R&S ESCI
1166.6004.12 4.46 E-2
Entry of Scan Data
Pressing the SWEEP key opens the menu to configure and start the scan.
SWEEP menu
CONTINUOUS
SCAN
USE SCAN
TABLE
SINGLE
SCAN
RUN
SCAN
SWEEP
RANGES
1-5 6-10
ADJUST
AXIS
INS BEFORE
RANGE
INS AFTER
RANGE
DELETE
RANGE
RUN
SCAN
CONT AT
HOLD
CONT AT
REC FREQ
STOP
SCAN
STOP
SCAN
HOLD
SCAN
USE CURR
SETTINGS
FREQ AXIS
LIN LOG
TIME
DOMAIN
FREQ AXIS
LIN LOG
10dB MIN
ON OFF
A scan is defined in the form of tables or it is performed using the current setting.
In the SCAN table, the scan subranges are defined . Each scan range is specified by start frequency,
stop frequency, step width and the measurement parameters that are valid for this range.
The scan can be performed as a single scan or continuously (softkeys SINGLE SCAN and
CONTINUOUS SCAN).
Scanning is started with the RUN SCAN softkey. .
To Next Page
Loading...
