Analyzer - Sweep R&S ESCI
1166.6004.12 4.92 E-1
SWEEP
POINTS
The SWEEP POINTS softkey selects the number of measurement samples
acquired during a sweep.
The following numbers of points per sweep are available:
251, 501 (Default),1001, 2001, 4001, 8001.
Note:
The autopeak detector will be disabled while the number of points per sweep
is
≠
501.
IEC/IEEE-bus command: SWE:POIN 501
SGL SWEEP
DISP OFF
The SGL SWEEP DISP OFF softkey deactivates the display while a single
sweep is being performed. Once the sweep has been completed, the trace is
shown.
IEC/IEEE-bus command: INIT:DISP OFF;:INIT
To Next Page
Loading...
