MKR FCTN - Analyzer R&S ESCI
1166.6004.12 4.134 E-1
NEW
SEARCH
The NEW SEARCH softkey starts a new peak search and enters
the results in the peak list.
IEC/IEEE-bus commands: INIT;*WAI;
CALC:MARK:FUNC:FPE 10;
CALC:MARK:FUNC:FPE:COUN?;
CALC:MARK:FUNC:FPE:Y?;
CALC:MARK:FUNC:FPE:X?
SORT MODE
FREQ LEVEL
The SORT MODE FREQ/LEVEL softkey defines the position of
the peak values in the list:
FREQ sorting in ascending order of frequency values (time
values if span = 0)
LEVEL sorting according to level
IEC/IEEE-bus command: CALC:MARK:FUNC:FPE:SORT X;
PEAK
EXCURSION
With level measurements, the PEAK EXCURSION softkey allows
the minimum amount to be entered by which a signal must
decrease or increase in order to be recognized as a maximum by
the peak search function.
Values between 0 dB and 80 dB may be entered, the resolution
being 0.1 dB
IEC/IEEE-bus command: CALC:MARK:PEXC 6dB
LEFT
LIMIT
RIGHT
LIMIT
The LEFT LIMIT and RIGHT LIMIT softkeys define the vertical
lines F1/F2 in the frequency domain (span > 0) and T1/T2 in the
time domain (span = 0) between which the search is carried out.
If only one line is active, the F1/T1 line is used as the lower limit;
the upper limit is the stop frequency. If F2/T2 is also active, it
defines the upper limit.
IEC/IEEE-bus commands: CALC:MARK:X:SLIM:LEFT 1MHZ
CALC:MARK:X:SLIM:RIGH 10MHZ
CALC:MARK:X:SLIM ON
THRESHOLD
The THRESHOLD softkey defines a horizontal threshold line
which represents the lower limit of the peak search level range.
IEC/IEEE-bus command: CALC:THR -20dBm
CALC:THR ON
PEAK LIST
OFF
The PEAK LIST OFF softkey switches off the table with the search
results.
IEC/IEEE-bus command: -
To Next Page
Loading...
