R&S ESCI Analyzer - MEAS
1166.6004.12 4.163 E-1
ACP LIMIT
CHECK
The ACP LIMIT CHECK softkey switches the limit check for the
ACP measurement on and off.
IEC/IEEE-bus command:
CALC:LIM:ACP ON
CALC:LIM:ACP:ACH:RES?
CALC:LIM:ACP:ALT:RES?
EDIT
ACP LIMITS
The EDIT ACP LIMITS softkey opens a table for defining the
limits for the ACP measurement.
The following rules apply for the limits:
• A separate limit can be defined for each adjacent channel.
The limit applies to both the upper and the lower adjacent
channel.
• A relative and/or absolute limit can be defined. The check of
both limit values can be activated independently.
• The R&S ESCI checks adherence to the limits irrespective of
whether the limits are absolute or relative or whether the
measurement is carried out with absolute or relative levels. If
both limits are active and if the higher of both limit values is
exceeded, the measured value is marked accordingly.
Note: Measured values exceeding the limit are marked by a
preceding asterisk.
IEC/IEEE-bus command:
CALC:LIM:ACP ON
CALC:LIM:ACP:ACH 0dB,0dB
CALC:LIM:ACP:ACH:STAT ON
CALC:LIM:ACP:ACH:ABS –10dBm,-10dBm
CALC:LIM:ACP:ACH:ABS:STAT ON
CALC:LIM:ACP:ALT1 0dB,0dB
CALC:LIM:ACP:ALT1:STAT ON
CALC:LIM:ACP:ALT1:ABS –10dBm,-10dBm
CALC:LIM:ACP:ALT1:ABS:STAT ON
CALC:LIM:ACP:ALT2 0dB,0dB
CALC:LIM:ACP:ALT2:STAT ON
CALC:LIM:ACP:ALT2:ABS –10dBm,-10dBm
CALC:LIM:ACP:ALT2:ABS:STAT ON
SELECT
TRACE
The SELECT TRACE softkey selects the trace on which the
CP/ACP measurement is to be performed. Only activated traces
can be selected, i.e. traces not set to BLANK.
IEC/IEEE-bus command:
SENS:POW:TRAC 1
To Next Page
Loading...
