Display R&S ESCI
1166.6004.12 4.196 E-1
The DISP key opens the menu for configuring the screen display and selecting the active diagram in
SPLIT SCREEN mode.
DISP
LINE S
FILE
SPLIT
SCREEN
FULL
SCREEN
CONFIG
DISPLAY
SCREEN
TITLE
ANNOTATION
ON OFF
LOGO
ON OFF
TIME+DATE
ON OFF
DEFAULT
COLORS 1
DEFAULT
COLORS 2
PREDEFINED
COLORS
TINT
SATURATION
DISPLAY
PWR SAVE
BRIGHTNESS
SELECT
OBJECT
DATA ENTRY
OPAQUE
SPLIT
SCREEN
FULL
SCREEN
REF LEVEL
COUPLED
CENTER B
= MARKER A
CONFIG
DISPLAY
CENTER A
= MARKER B
AnalyzerReceiver
PARAM
COUPLING
PARAM
COUPLING
BARGRAPH
RESET
BARGRAPH
MAXHOLD
FULL
SCREEN
The FULL SCREEN softkey selects the display of one diagram. This
corresponds to the default setting of R&S ESCI.
In Analyzer mode it is possible to switch between two different device settings
by selecting the active window (screen A or screen B).
Switching between SCREEN A and SCREEN B is performed by means of the
corresponding key in the HOTKEY bar:
SCREEN B
SPECTRUM
RECEIVER
MIXED
It should be noted that the measurements in the FULL SCREEN mode are
performed only in the visible (active) window.
The active window is marked by
A
or
B
on the right of the diagram.
In Receiver mode, the full screen always displays the scan.
IEC/IEEE-bus command: DISP:FORM SING
DISP:WIND<1|2>:SEL
To Next Page
Loading...
