R&S ESCI Windows XP
1166.6004.12 1.17 E-1
Windows XP
Caution:
The drivers and programs used under Windows XP are adapted to the measuring
instrument. In order to prevent the instrument functions from damage, the settings
should only be modified as described below.
Existing software may only be modified using update software released by Rohde &
Schwarz.
Additionally only programs authorized by Rohde & Schwarz for use on the R&S ESCI
may be run on the instrument.
Do not power down during booting. Such a switch-off may lead to corruption of
the hard disk files.
The instrument runs under the operating system Windows XP Embedded. The computer can be used to
install and configure device drivers that were authorized by Rohde & Schwarz. Any further use of the
computer function is only allowed under the conditions described in this operating manual.
Login
Windows XP requires a login process, during which the user is asked for identification by entering his
name and password. As a factory default the instrument is configured for Auto Login, i.e. the login is
performed automatically and in the background. The user name used for this is "instrument" and the
password is also "instrument" (in small letters).
Administrator level
The NT user account used for the autologin function has administrator access rights.
Windows XP Service Packs
The Windows XP Embedded system installed on the instrument includes Service Pack 1 for XP
Embedded.
Any service pack not approved by Rohde & Schwarz must not be installed since malfunctions
may occur. These malfunctions could impair measurements that are correctly performed on the
instrument and necessitate a repair.
The user is especially warned against using Service Packs of Windows XP Home or of the Professional
Edition, since these Service Packs are not compatible with Windows XP Embedded.
Calling the Windows XP start menu
The Windows XP start menu is called using the key combination <CTRL> <ESC>. It is possible to
access the required submenus from the start menu by means of the mouse or the cursor keys. In order
to return to the measurement screen the button "R&S Analyzer Interface" in the Windows XP task bar
can be used.
To Next Page
Loading...
