Recalling Data Sets R&S ESCI
1166.6004.12 4.240 E-1
Softkeys ENABLE ALL ITEMS / DISABLE ALL ITEMS are also available to select all partial data sets
or to cancel the selection.
! Move the entry focus to the field File Name using the spinwheel and activate the text entry by
pressing the spinwheel.
! Enter file names and store the data set with ENTER.
Loading a Data Set
A data set may be loaded in two different ways:
1. Direct entry of data set name:
! Press the FILE key and then press the RECALL softkey.
! Enter the name of the data set to be stored (in the simplest case, a digit from 0 to 9) and press
ENTER. The data set will be loaded.
The name of the data set may comprise letters and digits; if required, the desired directory may
precede the name of the data set (the directory will then automatically be used for further SAVE
and RECALL processes).
The help line editor, which can be opened by pressing the Cursor Down
key, is available for
entering file names via the front-panel keypad.
For further information on the operation of this editor, see section "Entering Text using the Help Line
Editor".
2. Selection of data set via a selection list:
! Press the FILE key and then press the RECALL softkey.
! Press the ITEMS TO SAVE/RCL softkey.
The list of available data sets will be selected:
! Select the data set to be loaded with the spinwheel and confirm twice with ENTER. The data set
will be loaded.
If the path for the device configuration is to be changed, this is done via the EDIT PATH softkey.
When loading device data, the settings of the unloaded partial data sets will remain unchanged. The
R&S ESCI recognizes which parts the loaded data set has and ignores selected but unavailable partial
data sets.
To Next Page
Loading...
