R&S ESCI Recalling Data Sets
1166.6004.12 4.241 E-1
Automatic Loading of a Data Set during Booting
When the R&S ESCI is delivered, it will load the device setting last activated when the unit was switched
off (provided that the unit was switched off via the STANDBY switch at the front panel, see section 1
"Putting the Device Into Operation").
Moreover, the R&S ESCI is also able to automatically load a user-defined data set. The following
operating steps are required:
! Press the FILE key and then press the RECALL softkey.
! Press the STARTUP RECALL softkey.
The list of available data sets will be selected:
! Select the data set to be loaded using the spinwheel and mark with ENTER.
Notes: 1. The selected data set will also be loaded when pressing the PRESET key.
2. The entry FACTORY will load the last setting that was activated prior to switch-off
when the unit is started after delivery.
! Close the dialog window by pressing ESC twice.
If the path is to be changed for the device configuration, this is done via the EDIT PATH softkey.
Copying Data Sets to Disk
The saved files of the data sets can be copied from one storage medium (e.g. drive D:) to another
storage medium (e.g. drive A:) or to another directory using the functions found in the FILE MANAGER
submenu. The file extension .ESCI must not be changed.
To Next Page
Loading...
