R&S ESCI Recalling Data Sets
1166.6004.12 4.247 E-1
SELECT
ITEMS
The SELECT ITEMS softkey moves the selection bar to the first line,
left column of the Items field. An entry is selected. Position the entry
focus to the corresponding partial data set using the cursor keys and
then press the ENTER key in the desired line. The selection is
cleared by pressing the key again.
IEC/IEEE command:
Current Settings: MMEM:SEL:HWS ON
All Limit Lines: MMEM:SEL:LIN:ALL ON
All Traces: MMEM:SEL:TRAC ON
Source Cal Data: MMEM:SEL:SCD ON
ENABLE
ALL ITEMS
The ENABLE ALL ITEMS softkey marks all partial data sets.
IEC/IEEE command: MMEM:SEL:ALL
ENABLE
ALL ITEMS
The ENABLE ALL ITEMS softkey marks all partial data sets.
IEC/IEEE-bus command MMEM:SEL:ALL
DEFAULT
CONFIG
The DEFAULT CONFIG softkey establishes the default selection of
the data subset to be saved and outputs DEFAULT in the ITEMS
field of the SAVE/RECALL DATA SET table.
IEC/IEEE command: MMEM:SEL:DEF
To Next Page
Loading...
