R&S ESCI Measurement Documentation
1166.6004.12 4.257 E-1
COLORS
The COLORS softkey gives access to the submenu where the colours for the
printout can be selected (see section "Selecting Printer Colours").
•
IEC/IEEE-bus command: -
COMMENT
The COMMENT softkey opens an entry field in which a comment of two lines
(60 characters per line) can be entered for screen A or B.
If the user enters more than 60 characters, the excess characters appear on
the second line on the print-out. At any point, a manual line-feed can be
forced by entering the @ character.
The comment is printed below the diagram area. The comment text appears
on the hardcopy, but not on the display screen.
If a comment should not be printed, it must be cleared.
If the instrument is reset by a click on the PRESET key, all entered comments
are cleared.
Note:
The COMMENT softkey opens the auxiliary line editor where the desired
letters can be entered in the text field by means of spinwheel and cursor
keys.
After clicking the COMMENT softkey, the auxiliary line editor can be reached
with the
key. Pressing the spinwheel or the ENTER key inserts the
selected characters in the text line.
After editing is completed, return to the text line with the
key and confirm
the comment text with ENTER.
If the entered comment should be aborted, quit the auxiliary line editor with
ESC.
Important:
Only after the auxiliary line editor has been closed with ESC can the
softkeys and hardkeys be operated again.
A detailed description of the auxiliary line editor can be found in section "
Entering a Text with the Auxiliary Line Editor ".
IEC/IEEE-bus command: HCOP:ITEM:WIND2:TEXT 'Comment'
HCOPY NEXT menu:
INSTALL
PRINTER
A certain number of printer drivers is already installed on the R&S ESCI.
The INSTALL PRINTER softkey opens the Printers and Faxes dialog where
more printer drivers can be installed.
For details refer to sections "Installation of Plug&Play Printers" and
"Installation of Non-Plug&Play Printers".
IEC/IEC-bus command: -
To Next Page
Loading...
