R&S ESCI External Generator Control - Configuration
1166.6004.12 4.291 E-1
CAL
TRANS
The CAL TRANS softkey triggers the calibration of the transmission
measurement.
It starts a sweep that records a reference trace. This trace is then used to
obtain the differences to the normalized values.
Fig. 4-35 Calibration curve for transmission measurement
During the calibration the following message is displayed:
After the calibration sweep the following message is displayed:
This message is cleared after approx. 3 seconds.
IEC/IEEE-bus command CORR:METH TRAN
To Next Page
Loading...
