R&S ESCI External Generator Control - Configuration
1166.6004.12 4.292 E-1
Normalization:
NETWORK -SOURCE CAL menu:
NORMALIZE
The NORMALIZE softkey switches normalization on or off. The softkey is
only available if the memory contains a correction trace.
It is possible to shift the relative reference point within the grid using the
REF VALUE POSITION softkey. Thus, the trace can be shifted from the top
grid margin to the middle of the grid:
Fig. 4-36 Normalized display
In the SPLIT SCREEN setting, the normalization is switched on in the
current window. Different normalizations can be active in the two windows.
Normalization is aborted when the NETWORK mode is quit.
IEC/IEEE-bus command: CORR ON
To Next Page
Loading...
