R&S ESCI External Generator Control - Configuration
1166.6004.12 4.293 E-1
REF VALUE
POSITION
The REF VALUE POSITION softkey (reference position) marks a reference
position in the active window on which the normalization (difference
formation with a reference curve) is performed.
When pressed for the first time, the softkey switches on the reference line
and activates the input of its position. The line can be shifted within the grid
limits.
The reference line is switched off by pressing the softkey again.
The function of the reference line is explained in the section "Functioning of
Calibration".
Fig. 4-37 Normalized measurement, shifted with REF VALUE
POSITION 50 %
IEC/IEEE-bus command DISP:WIND:TRAC:Y:RPOS 10PCT
To Next Page
Loading...
