R&S ESCI External Generator Control - Configuration
1166.6004.12 4.304 E-1
RESULT The frequency range of the generator resulting from the calculation
formula. An asterisk (*) after the upper limit indicates that the stop
frequency of the R&S ESCI must be adapted when the generator is
switched on in order not to exceed its maximum frequency. In the
following illustration, this is true for the upper generator at a stop
frequency of 3.2 GHz of the R&S ESCI, whereas the lower generator
does not yet require an adaptation:
IEC/IEEE-bus commands SOUR:EXT:POW –30dBm
SOUR:EXT:FREQ:NUM 4
SOUR:EXT:FREQ:DEN 3
SOUR:EXT:FREQ:OFFS 100MHZ
GEN REF
INT EXT
The GEN REF INT / EXT softkey switches over the reference oscillator of the
generator (switchover between internal and external reference source). The
internal reference source is selected as the default setting.
IEC/IEEE-bus command: SOUR:EXT1:ROSC INT
To Next Page
Loading...
