LAN Interface R&S ESCI
1166.6004.12 4.306 E-1
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* INSTUMENT RESTORE PROCEDURE V 1.4 (c) RSD 2002 *
* *
* Note: *
* The presence of the LAN-interface requires *
* a restore process different from the standard firmware *
* restore (due to the necessary network drivers). *
* *
* The following 3 selections will NOT destroy user defined *
* limit lines and transducer data *
* *
* Press 1 to perform standard system RESTORE *
* press 2 to perform system RESTORE with LAN interface *
* press 3 to ABORT system RESTORE *
* *
* The following selection will DESTROY user defined *
* limit lines and transducer data *
* *
* Press 4 to perform standard system RESTORE *
* (destroys user limit lines and transducers !!!) *
* press 5 to perform system RESTORE with LAN interface, *
* (destroys user limit lines and transducers !!!) *
* *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
! Press 2. Windows XP is newly installed on the analyzer partition of the hard disk with LAN support
and device firmware. The device may boot several times. At the end of the installation procedure,
the device firmware will be restarted.
The unit is again ready for operation. The configuration of the network protocols then has to be
performed according to the following sections.
To Next Page
Loading...
