R&S ESCI LAN Interface
1166.6004.12 4.333 E-1
Setting up the Connection with the R&S ESCI
After configuration of the remote desktop client, the connection with the R&S ESCI has to be set up.
! Click the General tab. The connection
information will be entered.
! Enter the IP address of the R&S ESCI in
the Computer field.
! The information can be stored via the
Save As... button for the next time. With
the Open... button, it is possible to load an
existing configuration again.
! Press the Connect button.
The connection will be set up.
Note:
If the entry Disk Drives is active in the
Local Resources tab, a warning is issued
that the drives will be shared for access
from the R&S ESCI:
Confirm the warning with OK. The setup
will be continued.
The R&S FSP screen will appear on the controller screen with the request to log in. To allow remote
control of the R&S ESCI, the following steps have to be carried out:
! Enter user name "instrument" and
password "instrument".
The R&S ESCI screen will be opened in a
few moments.
To Next Page
Loading...
