R&S ESCI The Screen
1166.6004.12 3.1 E-1
3 Manual Operation
Chapter 3 provides an overview of the operating concept and the basic steps of manual operation of the
R&S ESCI. This includes a description of the screen, of the control of menus and of the setting of
parameters. An overview of the menus will be listed at the end of this chapter.
The functions of the menus are described in detail in Chapter 4. Chapter 2 contains a short introduction
on step-by-step simple measurements. The remote control of the instrument is described in Chapters 5,
6 and 7
The operation of the spectrum analyzer is menu-controlled via keys, hotkeys and softkeys. The setting
of the instrument and test parameters in the menus is made either directly via softkeys or by entry of
values in entry fields and by selection in tables. The operating mode and the screen mode is selected
via the hotkeys.
If required, data entry windows and tables are superimposed on the screen.
The Screen
The screen informs continuously on the results and parameters of the selected measuring functions. It
shows the assignment of the softkeys and menus, which are required for setting the measuring
parameters. The display of test results, the softkey labeling and the type of menu depend on the
selected measuring function.
The screen is subdivided into three areas:
Diagramm area hotkey area softkey area
|||
Fig. 3-1 Subdivision of screen
To Next Page
Loading...
