R&S ESCI The Screen
1166.6004.12 3.9 E-1
Full Screen
In the full-screen mode, the settings and measurements are performed in the active visible window. All
indications on the screen refer to this window. The designation (SCREEN A or SCREEN B) is inserted
as enhancement label A or B on the right diagram margin.
Switching between the windows is by means of SCREEN A/B hotkey. The current measurement is
terminated when its window is blanked out.
Switching from split-screen to full-screen mode is performed in menu DISP.
Split Screen
In Split Screen mode, the screen is divided into two halves.
Fig.3-4 Subdivision of the screen in Split Screen mode
In the receiver mode, the screen is divided up according to fixed configurations.
Table 3-1 Default assignment of traces to windows with split screen in the receiver mode
upper (screen A) Indication of level and frequency
lower (screen B) Scan spectrum
In analyzer mode, the upper half is assigned Screen A, the lower one Screen B. The settings for
measurement can be selected independently for both screens. E.g., a spectrum may be displayed in
Screen A and a time amplitude in the time range is displayed in Screen B.
To Next Page
Loading...
