Setting Parameters R&S ESCI
1166.6004.12 3.22 E-1
Editing with Help Line Editor
If the external keyboard is not fitted, the help line editor is called automatically with entry of alphanumeric
parameters. The help line editor is an extension of the alphanumeric entry window. It contains the
complete alphabet with uppercase and lowercase letters as well as special characters in two lines of 52
characters, each. Individual letters and a series of special characters can be selected in the help line
editor and copied into the entry line.
The help line editor comes in two versions:
Version 1:
BCDEFGHIJKLM
DARD.CAL
help line editor
message line
input line
The cursor keys
or toggle between entry in the editing line and selection in the help line editor.
Entry of text ! Select parameter.
The data entry is active automatically upon calling the data entry
window. The cursor is positioned on the left in the editing line.
! Position the cursor in the help line editor using the cursor key.
The cursor marks the first letter of the editor.
! Locate the cursor on the character which is to be entered into the
editing line using the cursor keys
or
or the spinwheel.
! Press the ENTER key or the spinwheel
The character is entered in the editing line.
Correcting the entry
Terminating the entry
Aborting the entry
! Locate the cursor in the editing line using the cursor key .
! Position the cursor after the character which is to be deleted using
the cursor keys
and .
! Press the BACK key.
The entry left to the cursor is deleted.
! Locate the cursor in the editing line using the cursor key
.
! Press any unit key or the spinwheel.
The data entry window is closed, the new entry is accepted by the
instrument.
! Press the CLR key.
The data entry window is closed, the previous entry is retained.
To Next Page
Loading...
