Data Management
R&S
®
ESW
285User Manual 1177.6298.02 ─ 08
"Clipboard"
Copies the printout to the clipboard. Since only single pages can be
copied, only screenshots can be copied to this destination, not multi-
ple windows (see Chapter 12.6.1.1, "Print Content Settings",
on page 280). Page settings are not available; however, you can con-
figure the colors used for the screenshot (see Chapter 12.6.1.5, "Print
Color Settings", on page 287).
If you select the clipboard as the printing destination, the content set-
ting is automatically set to Print Screenshot.
"Printer"
Sends the printout to the printer selected from the Printer Name list.
Remote command:
HCOPy:DESTination<1|2> on page 597
HCOPy:DEVice:LANGuage<1|2> on page 597
Suppress File Name Dialog
If the Destination is a file, the file selection dialog box is not displayed. Instead, the
default storage location and filename are used.
(C:\R_S\Instr\User\ESW_ScreenShot_<date and time>).
Printer Name
Defines the printer to print to if a printer is selected as the Destination.
Any printers detected in the network are listed for selection.
Tip: the printout can also be stored in a print file using the selected printer driver, see
"Print to file" on page 285.
Remote command:
SYSTem:COMMunicate:PRINter:ENUMerate[:NEXT] on page 603
SYSTem:COMMunicate:PRINter:ENUMerate:FIRSt on page 603
SYSTem:COMMunicate:PRINter:SELect<1|2> on page 604
Print to file
If a printer is selected as the Destination, use this option to store the data in a .prn file
using the selected printer driver.
Install Printer
This softkey opens the standard Windows dialog box to install a new printer. All print-
ers that are already installed are displayed.
Only user accounts with administrator rights can install a printer.
For further information, refer to the Microsoft Windows documentation.
12.6.1.4 Page Setup
Access: "Print" > "Print Config" > "Page Setup" tab
Creating Screenshots of Current Measurement Results and Settings
To Next Page
Loading...
