General Instrument Setup
R&S
®
ESW
347User Manual 1177.6298.02 ─ 08
Relays Cycle Counter................................................................................................. 347
Relays Cycle Counter
The hardware relays built into the R&S ESW may fail after a large number of switching
cycles (see data sheet). The counter indicates how many switching cycles the individ-
ual relays have performed since they were installed.
Remote command:
DIAGnostic:INFO:CCOunt? on page 667
13.7 Synchronizing Measurement Channel Configuration
Access: [SETUP] > "Parameter Coupling"
Each of the applications of the R&S ESW is usually treated as an independent entity
regarding their configuration: changing a setting in one measurement channel does not
automatically change the corresponding setting in another channel.
For example, changing the frequency in the receiver application does not, by default,
change the frequency in the spectrum application.
However, sharing settings can be convenient for certain measurement tasks. The
R&S ESW provides a tool to couple (or synchronize) selected parameters across appli-
cations - the coupling manager.
The coupling managers allows you not only to couple parameters, but also markers
and lines accross applications.
● General Parameter Coupling................................................................................ 348
● Using the Custom Coupling Manager................................................................... 350
● Example for a User-Defined Parameter Coupling.................................................353
Synchronizing Measurement Channel Configuration
To Next Page
Loading...
