Rohde & Schwarz ESW Series - Page 463

Remote Commands in the Receiver Application
R&S
®
ESW
463User Manual 1177.6298.02 ─ 08
CALCulate<n>:PEAKsearch:CLEar[:IMMediate]................................................................464
CALCulate<n>:PSEarch[:IMMediate]............................................................................... 464
CALCulate<n>:PEAKsearch[:IMMediate]..........................................................................464
CALCulate<n>:PSEarch:MARGin.................................................................................... 465
CALCulate<n>:PEAKsearch:MARGin...............................................................................465
CALCulate<n>:PSEarch:METHod....................................................................................465
CALCulate<n>:PEAKsearch:METHod.............................................................................. 465
CALCulate<n>:PSEarch:SUBRanges:PCOunt.................................................................. 465
CALCulate<n>:PEAKsearch:SUBRanges:PCOunt.............................................................465
CALCulate<n>:PSEarch:SUBRanges...............................................................................466
CALCulate<n>:PEAKsearch:SUBRanges[:VALue].............................................................466
DISPlay[:WINDow<n>]:TRACe<t>:SYMBol.......................................................................466
MMEMory:STORe:FINal................................................................................................. 467
MMEMory:STORe:PLISt.................................................................................................467
CALCulate<n>:MARKer<m>:PEXCursion <Excursion>
This command defines the peak excursion (for all markers in all windows).
The peak excursion sets the requirements for a peak to be detected during a peak
search.
The unit depends on the measurement.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<Excursion> The excursion is the distance to a trace maximum that must be
attained before a new maximum is recognized, or the distance to
a trace minimum that must be attained before a new minimum is
recognized
*RST: 6 dB
Example:
CALC:MARK:PEXC 10dB
Defines peak excursion as 10 dB.
Manual operation: See "Defining peak characteristics" on page 126
See "Peak Excursion" on page 235
CALCulate<n>:PSEarch:ADD <Frequency>
CALCulate<n>:PEAKsearch:ADD <Frequency>
This command manually adds a particular frequency to the peak list, regardless if the
level threshold conditions have been fulfilled for that frequency.
Note that the frequency has to be in the displayed frequency range.
Suffix:
<n>
.
irrelevant
Setting parameters:
<Frequency>
Measurements and Result Displays