Rohde & Schwarz ESW Series - Page 481

Remote Commands in the Receiver Application
R&S
®
ESW
481User Manual 1177.6298.02 ─ 08
L2
Available for networks with four phases (R&S ESH2Z5,
R&S ENV4200 and R&S ENV432)
L3
Available for networks with four phases (R&S ESH2Z5,
R&S ENV4200 and R&S ENV432)
N
*RST: L1
Example: //Select phase L1
INP:LISN:PHAS L1
Manual operation: See "Phase" on page 136
INPut<ip>:LISN[:TYPE] <Type>
This command turns automatic control of a LISN on and off. It also selects the type of
network.
Suffix:
<ip>
.
irrelevant
Parameters:
<Type> ENV216
R&S ENV 216: two phases and highpass are controllable.
ENV432
R&S ENV 432: four phases are controllable.
ENV4200
R&S ENV 4200: four phases are controllable.
ESH2Z5
R&S ESH2-Z5: four phases (incl. protective earth) are controlla-
ble.
ESH3Z5
R&S ESH3-Z5: two phases (incl. protective earth) are controlla-
ble.
FOURphase
R&S ESH2-Z5: four phases (incl. protective earth) are controlla-
ble.
OFF
Turns off control of the LISN.
TWOPhase
R&S ESH3-Z5: two phases (incl. protective earth) are controlla-
ble.
*RST:
OFF
Example: //Select LISN
INP:LISN:TYPE TWOP
Manual operation: See "LISN Type" on page 136
Measurements and Result Displays